Raptor RACE Wireless Switch Panel
The RAPTOR is a 2 piece system comprising of the Transmitter Assembly and a 12v 8 Channel Relay Module.
The Transmitter Assembly houses all of the transmission electronics beneath a central cap, and once removed, you can access the CR2032 3V battery to replace at any time. The transmitter cap also allows the Battery Status LED to show through, providing an easy to see coloured status of the remaining battery condition. The LED is only activated when a button is pressed on the board. The 8 Channel Relay receiver has selectable operational modes for each individual relay. Each Relay can react to button presses in the following ways;
- MOMENTARY ACTION (Press and Hold)
- LATCHING ACTION (Press once to Lock, Press again to Unlock)
- FLASHING ACTION (For both Momentary and Latching states)
These combinations allow you to fully customize the RAPTOR to suit your application. You can wire the receiver into your vehicle and operate electrical systems such as Headlights, Indicators, ECU Maps, Traction Control .... The list is endless !
The 'FLASH RATE' for the Race Version of the Raptor has been set at 4 times per second. This gives you a nice rate for a 'Flash to Pass' option when the system is connected to your Race Car Headlights.
In the box you receive the Raptor Transmitter Plate, the 8 Channel Relay Receiver, Wiring Loom with over braid, 1 x CR2032 Button Cell Battery and a set of Installation Instructions. Additional batteries, Wiring Looms and Transmitter Caps are available to purchase separately.